LED Teapot Lamp

Materials;

2 LED lights

6 inches wire

1 teapot

2 3 volt batteries

1 Battery pack

Step one; Attach 2 LEDs together, attaching the negative leg
to the positive leg. Use a soldering iron.

Step two; Add length to the LEDs by soldering extra wire to
the tips.

Step three; Thread the wire through the spout of the teapot.
Pull it through until only the 2 LEDs are showing.

Step four; Tape the copper tape to the edges of the rim, and
to the lid of the pot. Run the tape down towards the wires from the LED.

Step five; Tape or solder the wires to the tape.

Step six; Cut a line in the copper tape in the pot and attach
the wires from your battery pack to the corresponding positive and negative
sides.

Step seven. Close the lid and line up the copper tape on the
lid to the rim, and voila!